HOW TO MEASURE AND PUT ON YOUR MASTHEAD BRA
Step 1: Determine Your Bra Size
- Measure around fullest part of bust.
- Look up corresponding size on the Masthead® bra size chart (above).
- If there will be padding or dressing applied, select one size larger.
Step 2: Unpack and Put on Bra
When putting bra on patient in the OR:
- Remove bra from plastic packaging.
- Open shoulder, side, and front Velcro fasteners.
- Place opened bra completely flat on table under drapes, with inside of bra facing up.
- At the completion of surgery, after drapes are removed, wrap the bra around patient and close front Velcro.
- Close and adjust shoulder openings.
When patient is putting bra on herself:
- Remove bra from plastic packaging.
- Open front Velcro closure, put on bra.
- Re-close shoulder fasteners on bra by pressing end of front hooked Velcro tab onto end of soft back looped tab.
Step 3: Adjust for JP Drains
For patient with drains:
- Tunnel JP drain tubing through opening on side of bra nearest surgical site.
- Twist/unsnap ring hanging from front of bra to open.
- Attach plastic loop on bulb to plastic ring, snap ring closed.
- If using bra with convertible loops and rings, move the loops/rings to the side needed, and save the removed loop(s)/ring(s).
For patient without drains:
- At provider's discretion, cut off drain loops/plastic rings (but save the rings--they may come in handy).
Step 4: Adjust Velcro Closures
- Close Velcro from bottom to top along center opening.
- Adjust Velcro shoulder tabs and side closures for secure but comfortable fit.
- Bra closures can be easily loosened or tightened as necessary.
Step 5: Washing Instructions
- Close all Velcro before laundering.
- Wash in warm water with mild detergent gentle cycle, line dry.
- DO NOT PUT IN THE DRYER.